RCH
INSTALLATION AND MAINTENANCE MANUAL model TOUCH ME
- 61 -
E41
"OVERFLOW RECEIPT [CL] "
The amount of the current receipt has exceeded the allowed limit. Cancel the receipt
or close it and open a new one concerning the non-registered items.
E42
"DAILY NET OVERFLOW [CL] "
The SALES adding machine has reached its limit. Close or cancel the current receipt
and perform a fiscal daily report.
E43
“PROGR NET OVERFLOW [CL] "
The Cash counter has reached the maximum value that may be reached as Grand
Total. Close or cancel the current receipt and ask for RCH service.
E44
"ITEMS OVERFLOW [CL] "
It indicates it has reached the maximum number of items that may be recorded onto
the current receipt. Close the receipt and open a new one to record the missing
items.
E45
“CHANGE NOT ADMITED [CL] "
The closing total utilised is programmed not to accept any change. Use another Total
or re-program the one used.
E51
"FISCAL MEMORY ALREADY SET [CL] "
Performing the serialisation procedure is not possible (already done by the
manufacturer).
E52
"DATA NOT CLEARED [CL] "
It indicates that before continuing performing a fiscal daily report is mandatory.
E60
"PAPER OUT Press [CL] "
It indicates that the paper roll has finished. Replace the roll paper as indicated in
chapter 12 of the operating manual.
E61
“HEAD ERROR Press [CL] "
It indicates that the thermal head connector (printer) is disconnected from the printer
logic card.
E62
“POWER ERROR Press [CL] "
It indicates that the cash counter is improperly fed. Contact RCH service centre to
verify the feeder.
E63
“PRINTER ERROR Press [CL] "
It indicates anomalous printer operations. It may indicate the incorrect closing of the
upper part or that some connectors are disconnected from the logic card. Should the
problem continue, contact RCH service centre.
E64
“HEAD UP [CL] "
It indicates that the replacement of the paper roll was improper. Read again chapter
12 of the operating manual. Should the problem continue, contact RCH service
centre.
E65
"CUTTER ERROR [CL] "
It indicates the presence of paper stuck in the cutter. Remove the paper and press
CL . Should the problem continue, contact RCH service centre.
E70
“LOW BATTERY [CL] ”
The battery is down; re-charge the battery and continue the sales.
E80
"FISCAL MEMORY NOT CONNECTED"
It indicates that the fiscal memory is disconnected. Contact RCH service centre to
reinstate its working.
E81
“ERROR READ FISCAL MEMORY"
It indicates a problem to access the fiscal memory. Switch off and switch on again the
cash counter. Should the problem continue, contact RCH service centre.
E82
“ERROR WRITE FISCAL MEMORY"
It indicates a writing problem onto the fiscal memory. Contact RCH service centre.
E83
“FISCAL MEMORY FULL!"
It indicates that all the settings to zero available have been completed (2000). Call
RCH service centre.
