Raymarine CAM300, Инструкция по установке и эксплуатации

Страница: 48 / 94

13.3 Accessing the camera's IP address via a
Raymarine® MFD
The following instructions are subject to change depending upon which
version of LightHouse™ your multifunction display is running. The instructions
listed below are only applicable to multifunction displays running LightHouse™
4 or LightHouse™ 3. For further information on how to access the diagnostic
product information menu, refer to the LightHouse™ Operation Instructions
manual which is relevant to your display.
Before proceeding, ensure that your display has been setup in
accordance with the instructions provided within the following section:
p.44 — Setting up the camera via a Raymarine® MFD
In order to access the camera’s IP address using your MFD’s diagnostic
product information, follow the steps listed below:
1. Ensure that your product and multifunction display are connected to the
same network as your Windows 10 or Apple Mac PC.
2. Select [Homescreen > Settings > Network > Diagnostics > View all
product info] .
3. Scroll down the list of [Product information] until you find the CAM300’s
[IP address] .
You can now access the CAM300’s Web interface by typing the IP address
found under the
[Product information] list into one of the supported Web
browsers in the following format: http://xxx.xx.x.xxx .
IP cameras can take up to 60 seconds to appear on a network. If the CAM300
does not appear under your multifunction display
[Product information] or
[Network] device list, ensure that you have waited a sufficient amount of time
before attempting to [Refresh] via the [Network] menu.
If you cannot access the Web browser user interface after entering the
camera’s IP address into your default browser, ensure that your computer is
on the same IP address range as the camera before retrying.
Note:
For further information on which Web browsers are supported, refer to the
following section:
p.50 — Supported browsers
For further information on how to change your computer’s IP address
range, refer to one of the following sections:
• p.48 — Changing the IP address range on a Windows 10 PC
• p.49 — Changing the IP address range on an Apple Mac PC
It is recommended that your PC is restarted after the IP address has been
changed.
13.4 IP address range
In some cases the IP address range of your computer and product will not
match, meaning that you are unable to connect to the product. This issue
can be resolved by assigning your computer an IP address on the same
IP address range as your product.
Changing the IP address range on a Windows 10 PC
To configure the necessary IP address range settings on a Windows 10 PC,
follow the steps listed below:
Note:
You will need to know the IP address of your product for step 10. This can
be found by referring to one of the following sections:
• p.47 — Accessing the camera’s IP address via ONVIF Device Manager
• p.48 — Accessing the camera's IP address via a Raymarine® MFD
1. Click [Start] .
2. Click [Settings] .
3. Click [Network and Internet] .
4. Click [Change adapter options] .
5. Select and right click the [network] the product is communicating on.
6. Click [Properties] .
7. Scroll to [Internet Protocol Version 4 (TCP/IPv4)] and select it.
48