Raymarine CAM300, Инструкция по установке и эксплуатации

Страница: 54 / 94

Image Control
Menu item and description Option(s)
[Image Mode]
Enables you to change the Image Mode setting
between one of the following modes:
Standard Mode
• Sets the Image Mode setting to default.
Faceless Exposure Mode
• Automatically adjusts the camera’s exposure
levels depending on how far a person is from the
camera lens.
Licence Plate Mode
• Enhances the camera’s video image in order to
make vehicle licence plates easier to read.
• [Standard Mode]
• [Faceless
Exposure Mode]
• [Licence Plate
Mode]
[IR-CUT Mode] (3)
Enables you to set the camera’s infrared filter as
permanently open, closed, or to automatically cycle
between open and closed based upon the current
time / environmental lighting conditions.
• [Automatic
(Passive Mode)]
• [Automatic (Active
Mode)]
• [Day]
• [Night]
• [Timing]
[IR-CUT Sensitivity] (2)
N / A
[IR-CUT Delay] (3)
Enables you to change how long (in seconds) the
environmental lighting conditions must remain the
same before the infrared filter changes position.
This setting is only available if you have set the
IR-CUT Mode setting to Automatic (Passive Mode)
or Automatic (Active Mode).
• [3] — [15]
Menu item and description Option(s)
[Day Time]
Enables you to set a specific start and end time
when the camera’s infrared filter will be closed.
This setting is dependent upon your camera’s time
configuration.
In order to configure your time and date settings,
navigate to:
[Remote Setting > System Config >
Time Setting] .
This setting is only available if you have set the
IR-CUT Mode setting to Timing.
• [Start Time]
• [End Time]
[IR-CUT Reverse]
Enables you to reverse the infrared filter activation
trigger when set to Open. This causes the filter
to retract when light levels are high, allowing the
sensor to access more light (including infrared light).
• [Open]
• [Close]
[Brightness]
Enables you to change the Brightness value of the
camera’s image.
By default, the Brightness value is set to 50.
• [0] — [100]
[Contrast]
Enables you to change the Contrast value of the
camera’s image.
By default, the Contrast value is set to 50.
• [0] — [100]
[Saturation]
Enables you to change the Saturation value of the
camera’s image.
By default, the Saturation value is set to 50.
• [0] — [100]
[Hue]
Enables you to change the Hue value of the
camera’s image.
By default, the Hue value is set to 50.
• [0] — [100]
54