Raymarine CAM300, Инструкция по установке и эксплуатации

Страница: 44 / 94

12.1 Setting up the camera via a Raymarine®
MFD
The CAM300 must be connected to the same network as your multifunction
display in order for it to be detected.
Before attempting to establish a connection between your Raymarine®
multifunction display and the camera, ensure that you have read and
understood the relevant power connection safety information found within
the following sections:
• p.32 — Network connections
• p.35 — PoE power connections
• p.38 — Non-PoE power connections
If you have previously changed the [IP Type] , [Auto IP] or [Video Codec]
Web interface settings before attempting to connect the CAM300 to your
multifunction display, you may experience Video app display issues or
camera detection difficulties. Ensure that these settings have been reverted
to default before attempting to use the CAM300 with your multifunction
display.
In order to setup the camera for use with your Raymarine® multifunction
display, follow the steps listed below.
1. From the
[Diagnostics] menu: [Homescreen > Settings > Network >
Diagnostics > DHCP] .
2. Select the [Automatic] option.
3. Press the [Refresh] button.
An IP camera can take up to 60 seconds to appear on a network. If
the CAM300 does not appear under your multifunction display
[Product
information] or [Network] device list, ensure that you have waited a sufficient
amount of time before attempting to [Refresh] via the [Network] menu.
If correctly configured, the CAM300 will appear on the Raymarine®
multifunction display
[Network] tab and the Video app live camera feed.
If you are experiencing issues, ensure that you have read and followed the
information listed above before referring to the troubleshooting advice found
within the following section:
p.69 — Troubleshooting
12.2 Camera operation via the Raymarine® MFD
Video app
The CAM300’s video feed can be viewed by using a connected Raymarine®
multifunction display running LightHouse™ 2 and above.
The Raymarine® multifunction display Video app enables you to view,
record and play back footage from a connected IP (Internet Protocol)
digital video feed. For further Video app information, refer to the
LightHouse™ Operation Instructions manual which accompanies your display:
www.raymarine.com/manuals
Note:
• The CAM300 video feed can be displayed across a maximum of 3
Raymarine® multifunction display Video apps at the same time.
• The video streams of up to 4 CAM300 cameras can be displayed
simultaneously on a single compatible Raymarine® multifunction display.
Multifunction display software version
To ensure optimum performance and compatibility with external devices,
your multifunction display must be using the latest software version.
Visit www.raymarine.com/software to download the latest software.
44