Introduction: Initial Configuration
American Science and Engineering, Inc.
MINI
Z
Operator Manual 342-9000-1 Rev. B ECCN EAR99
3-39
3.6.7
ASEI Laser Guide Beams
(Requires a connection to the Scanner)
The MINI Z has two Class 1 red laser beams that can emit from the front of the scanner unit to allow
the operator and bystanders to see the outer bounds of the direct X-ray emission beam (
Figure 2-5
).
The beams can be enabled for automatic operation whenever the scanner unit is emitting, or the beams
can be kept turned off:
•
Enabled
– The laser beams are automatically illuminated during scanning.
•
Disabled
– The laser beams are not turned on.
To set the state, use a supervisor-level user account to perform the following steps:
1. In the tablet ASEInspection Software
Home Screen
, tap the
Settings
button
. The
Settings
screen opens.
2. At the top of the screen, if necessary, tap the
General
button. The
General
screen appears (see
Figure 5-11
).
3. In the
Scanner
table, tap the
Laser
drop-down box to open the list.
4. Tap the required option. The list closes. It is not necessary to restart the scanner.
3.6.8
ASEI Automatic Login
(Requires supervisor account)
When the system is shipped from the factory, the Automatically Login User feature (login without
password) feature is enabled by default to allow a supervisor (SITEADMIN) account to open for sys-
tem set-up. It is recommended that, during these initial procedures, the password policies be reconfig-
ured so either no account, or at most an Operator-level account, can be logged in automatically when
the system is turned on.
1. In the
Home Screen
, tap the
Settings
button
.
2. If necessary, at the top of the screen, tap the
Policies
button. The
Settings: Policies
screen opens.
3. To allow automatic login of a user account, in the
Automatically login user
group, tap the list box
to open it, and then tap an Operator-level account (do not change the slider position, it should
remain so the label indicates
On
). Otherwise,
4. To prevent any automatic login of any user account, in the
Automatically login user
group,
change the slider position; it should moved so the label indicates
Off
.
3.6.9
ASEI Display Language
(Requires supervisor account)
To change the user language used in the tablet screens, perform the following steps:
Содержание AS&E MINI Z
Страница 6: ...American Science and Engineering Inc vi MINI Z Operator Manual 342 9000 1 Rev B ECCN EAR99 ...
Страница 12: ...American Science and Engineering Inc x MINI Z Operator Manual Rev B ECCN EAR99 ...
Страница 26: ...Basics American Science and Engineering Inc Basics vi MINI Z Operator Manual 342 9000 1 Rev A ECCN EAR99 ...
