Rapid 7500 136, Инструкция по установке, эксплуатации и обслуживанию

Страница: 150 / 156

7500-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
138 of 143
Burner Control Module (continued)
Additional tro ub le shooting information can b e fo u nd
in the Flame Safeg u ard Control bu lletin s u pplied w ith
the air t u rno v er u nit.
BLINK CODE SYSTEM FAILURE RECOMMENDED TROUBLESHOOTING
Code 6-3*De v ice Specific* Fa u lt w ith special OEM inp u t
circ u its.
1. Check w iring and operation of special OEM inp u ts.
2. Reset and seq u ence the relay mod u le.
3. If fa u lt reappears, remo v e po w er from the de v ice, reapply
po w er, then reset and seq u ence the relay mod u le.
4. If the fa u lt does not repeat on the next cycle, check for
electrical noise b eing copied into the relay mod u le
thro u gh the external loads or possi b ly an electrical
gro u nding iss u e.
5. If the fa u lt persists, replace the relay mod u le.
Code 6-4*Accessory
Fa
u lt*
VPS set u p. 1. Make s u re Relay Mod u le VP is programmed.
2. T6 and T17 po w ered at the same time—correct w iring.
3. Reset control if fa u lt persists. Replace relay mod u le.
Code 7-7*Un u sed* Un u sed at this time. -