9
Locations 080-095: Programming Phone #1
Phone #1 is programmed in successive locations beginning with location 080. Delays of four seconds can be
programmed at any point in the phone number by programming a "13" in the appropriate location. Program “11" for
the phone digit “
r
”. Program “12 for the phone digit “#”. If tone dialing is desired, program a "15" in the location
where tone dialing should begin. If the entire number should be tone dialing, program a "15" in location 080. Factory
default is "14" in each location and the phone number is not enabled. When using split or dual reporting, phone #1
always takes priority over phone #2. A "14" indicates the end of the phone number.
Locations 096-100: Programming The Account Code For Phone #1 (Or Partition One)
The account code sent when phone #1 is dialed is programmed in locations 096-100. If the account code is three
digits long, use locations 096, 097, 098, and program a "0" in locations 099 and 100. If the account code is four
digits long, program a "0" in location 100. If a zero "0" is part of an account code, it should be programmed as a "10".
Program a "0" to indicate the end of the account code. To make this account code the account code for "Partition
One", see location 132.
Location 101: Communicator Format For Phone #1
Location 101 contains the communicator format used to transmit to the receiver connected to the phone #1. Consult
the instructions for your central station receiver to determine which format is compatible. Select a format from the
14 listed on page 10. If you require a format other than those listed, review the override options described in
locations 610-615, to build the appropriate format. A "15" must be programmed in location 101 in addition to the
entries into locations 610-615 in order to create a special format. If this location contains a "0", the built-in
communicator will be disabled, and the Ranger 9000E will function as a local only control.
Locations 102-117: Programming Phone #2 (Split or Dual)
Locations 102-117 contain phone #2. This number allows certain communicator reports to go to another number
(split reporting), or to cause the communicator to dial a second number if the primary number does not respond after
the number of attempts programmed into location 133 have been tried unsuccessfully, or for dual reporting. The
same number of attempts are made with the back-up number. Tone dialing and delay instructions are the same as
for the primary number. A "14" indicates the end of the phone number.
Locations 118-122: Programming The Account Code For Phone #2 (Or Partition Two)
Locations 118-122 contain the account code for phone #2. If the account code is three digits long, use locations 118,
119, and 120. If a zero "0" is part of the account code it must be programmed as a "10". Program a "0" to indicate
the end of the account code. If these locations contain a "0", the account code in locations 96-100 will be reported.
To make this account code the account code for "Partition Two", see location 132.
Location 123: Communicator Format For Phone #2
Location 123 contains the communicator format used to transmit to the receiver connected to phone #2. Consult the
instructions for your central station receiver to determine which format is compatible. Select a format from the chart
on page 10. If you require a format other than those listed, review the override options described in locations 610-
615 to build the appropriate format. A "15" must be programmed in location 123 in addition to the entries into
locations 610-615 in order to create a special format. If this location contains a "0", the format programmed into
location 101 will be selected.
