27
GB
Setting speeds, automatically and manually
Automatically setting of the speed by selecting the type of mounting:
The speed can be set automatically contingent on the type of mounting (running into the wall or
running on the wall) in order to reduce the risk of injury (through impact or crushing) at the
closing edges of a sliding door or sliding shutter.
Type of mounting
Setting
The sliding unit runs into the wall.
=
The sliding unit is mounted on the wall.
=
(factory setting)
Correlation between type of mounting and speed
Setting
Description
= fast opening / slow closing
= slow opening and closing
NOTE
Speed setting in compliance with safety standards.
The speed is set at the factory so as to comply with the maximum forces for a sliding door or for
a sliding shutter, as set out in the relevant safety standards, where the maximum weight of the
sliding unit is 80 kg. If necessary, the speed can be adjusted (raised) if lighter sliding units are
used.
Manual adjustment of the opening speed.
Alternatively the opening speed can also be set manually (see page 28).
IMPORTANT
Repeating the end point search and reference runs.
Every time the type of mounting or the speed is altered, the end points, as well as the reference
run settings, are automatically deleted and must be repeated (see page 22/23).
Extending the braking distance.
When the opening speed has been increased it may be necessary to extend the braking distance
in order to ensure smooth operation (see page 25).
