RACOM RAy11, Руководство пользователя

Страница: 49 / 177

d. Separate individual pairs of conductors, remove the aluminium shielding from them, cut it off, and
separate individual conductors. Cut off the two additional twisted pairs from the thinner wire in the
middle (not seen on these images).
Fig. 5.37: Trimming shielding Fig. 5.38: Separated pairs of conductors
e. Push the lower layer of conductors into the openings as per the pinout sticker (T568B) attached
to the connector. Take care not to confuse white conductors from individual pairs.
Fig. 5.39: Pushing the lower pairs
into the connector Fig. 5.40: Lower pairs pushed in
f.
Then from above push the upper conductors into
the connector according to the pinout sticker and trim them. The cable must be pushed in far
enough so that the braided shielding is inside the metal part of the connector.
Fig. 5.41: Cutting off of the upper conductors Fig. 5.42: All conductors in the connector
49 © RACOM s.r.o. – RAy Microwave Link
Installation