RACOM RAy11, Руководство пользователя

Страница: 50 / 177

g. Remove the pinout sticker and fit the complementary half of the connector. Squeeze the parts to-
gether until the locks snap into place. Use the pair of pliers with parallel jaws from the
RAy Tool
set for this. Standard pliers would damage the connector.
Fig. 5.43: Fitting the complementary half
of the connector Fig. 5.44: Squeezing the connector until the
locks snap into place
h. Then slide the protective cover onto the connector. It must fit into the grooves after snapping into
place. Finally tighten the nut on the cover to seal the point where the cable enters the connector.
Fig. 5.45: Sliding the cover onto the connector Fig. 5.46: Finished IE-PI-RJ45-FH connector
5.3.3. Fitting an internal IE-PS-RJ45-FH-BK connector
a. Use the same tools as for fitting the external connector. The internal connector does not have a
cover.
Fig. 5.47: IE-PS-RJ45-FH-BK connector
before fitting Fig. 5.48: Finished connector
IE-PS-RJ45-FH-BK
RAy Microwave Link – © RACOM s.r.o. 50
Installation