IQ3 Drag Dash Installation Manual
39
9.
Click on the OK button.
a.
If the ECU interface was turned on using the pushbuttons/Setup Mode 1 you
should now see a new channel buttons (boxes) for each channel.
b.
If the ECU interface was not previously enabled, you can do so using the
pushbuttons/Setup Mode 1, and then repeat the Read process after which the
new ECU channels will appear.
c.
If the ECU interface was not previously enabled, you can do so using the
DataLink Software,
i.
navigate to the Dash Info tab by right clicking on the main channel button
labeled
IQ3 Logger
ii.
Select Dash Info tab, locate the listing ECU Type under the Custom
Programming Options
iii.
Click on ECU type and select your ECU from the drop down list on the
right
iv.
Select Send Configuration
v.
Exit the LCD Dash Configuration window to return to the main
configuration window and repeat the Read process after which the new
ECU channels will appear
10.
Right click on any of the channel boxes to modify/change their parameters.
11.
Once any change is made, you must select
Send Configuration
to send change to the
dash.
12.
The channels are now ready to be selected and programmed to the Display pages.
Содержание IQ3 Drag Dash
Страница 2: ...IQ3 Data Logger Dash Installation Manual 2...
Страница 4: ...IQ3 Data Logger Dash Installation Manual 4...
Страница 32: ...IQ3 Data Logger Dash Installation Manual 32...
Страница 62: ...IQ3 Data Logger Dash Installation Manual 62...
