Racepak IQ3 Drag Dash, Руководство по установке

Страница: 29 / 63

IQ3 Drag Dash Installation Manual
29
Water Temperature Sensor Settings
The dash is pre-configured at the factory to use a supplied two-wire 0-300 °F temperature
sender for Water Temperature on Pins #23 (Black wire, sensor ground), #24 (Clear wire, signal).
The option to use other sensors instead of the supplied two-wire temperature sensor is
available as well as using this input for other parameters beside water temperature. When
using powered sensors, extra terminals are available on rear connector of dash for 5 volt power
and ground.
#
Wires
ONSCREEN
NAME
R
ANGE
N
OTES
& S
CALING
1 RP DEG-F 0 - 250 °F Racepak Single Wire #800-TR-250 Ω style with 499 Ohm pull-up
2 RP DEG-F 0 - 300 °F Racepak Two Wire #800-TR-300 Ω style with 4.42K Ohm pull-up
2 GM DEG-F 0 - 300 °F GM/Delphi Two Wire #12146312 Ω style with 499 Ohm pull-up
1 RP DEG-C -18 - 121 °C Racepak Single Wire #800-TR-250 Ω style with 499 Ohm pull-up
2 RP DEG-C -18 - 149 °C Racepak Two Wire #800-TR-300 Ω style with 4.42K Ohm pull-up
2 GM DEG-C -18 - 149 °C GM/Delphi Two Wire #12146312 Ω style with 499 Ohm pull-up
User Cal Custom user scale
Disabled Disabled, input is not used and will not stream/record data
0-5 volts
0-5 volt input, must use software to program, Raw Data A, Raw
Data B, Min, Max Result Values