Racepak IQ3 Drag Dash, Руководство по установке

Страница: 20 / 63

IQ3 Data Logger Dash Installation Manual
20
External V-Net Sensor Connection (optional add ons 6 maximum)
When installing any optional additional sensors to the IQ3 Drag Dash, it will utilize the Racepak
V-Net (CAN bus) for input. These added sensors are connected using “stackable” modules that
connect to the round 5 pin V-Net port on the rear of the dash. This design provides the ability
to transmit all sensor data through a single cable by use of these “stacking” modules. A cap is
then placed at the end of the “stack” to terminate the system. The modules are typically
available with sensors in kit form. Extension cables are available in a variety of lengths to
connect multiple “stacks” of modules that may be installed in different locations throughout
the vehicle.
To add sensors, the customer simply measures from the IQ3 Drag Dash to the mounting
location of the “stackable” module or modules, and orders the appropriate length pre-
terminated V-Net extension cable. V-Net cables are available in 12” increments and are
equipped with a male connector on one end and a female
connector on the opposite end. In the event sensors are
mounted in multiple locations throughout the vehicle, simply
measure between each sensor location and order the necessary
V-Net extension cables to connect all items to the main V-Net
cable routed to the rear of the dash.
Any V-Net sensor currently offered by Racepak may be utilized by the IQ3 Drag Dash. For a
complete listing of available sensors, visit our website located at
www.racepak.com or contact
the Racepak customer service department at 949-709-5555 for a catalog. Customer supplied
sensors may also be utilized. DataLink software is used to both set up and configure the IQ3
Drag Dash using a Windows based PC. It will be used to modify any settings, page layouts,
warning light settings, add additional sensors, etc. See Programming the
Display Using the
DataLink Software section shown later in this manual for further details.
Sensors
Terminator
cap
V-Net Extension Cables
V-Net Modules