Quantum P1000 Series, Руководство пользователя

Страница: 122 / 132

Appendix B Installing the Slide Assembly in the Rack
Adjusting the Slide Assembly
106 ATL P1000 Series User’s Guide
Figure 58 Loosening the
Inner Nuts
Procedure
3
When the slide assembly tray is in the desired position, tighten all
inner nuts:
a
Extend the slide assembly out of the rack until both the
intermediate and inner channels of the slide rails lock (see
figure 57 on page 105).
This allows you to access the front screws.
b
Tighten each of the front nuts by holding the nut with an
11/32 inch open-ended wrench and then tightening its
corresponding screw with a Phillips screwdriver.
c
Press on the inner channel locks to release them (see figure 57
on page 105).
d
Push the slide assembly back into the rack until the access hole
on the outside of the inner channel exposes a screw.
e
Use a Phillips screwdriver to tighten the screw while holding
its corresponding nut with an 11/32 inch open-ended wrench.
f
Repeat steps 3d and 3e to tighten the remaining inner nuts.
g
Push the slide assembly tray back into the rack.
4
Check for adequate clearance. If necessary, repeat this procedure to
adjust the slide tray further.
Inner nuts
Inner nuts