Quantum P1000 Series, Руководство пользователя

Страница: 49 / 132

Chapter 2 Installing the P1000 Library
Preparing and Inserting Tape Cartridges
ATL P1000 Series User’s Guide 33
Procedure (continued)
2
Remove the load and bulk packs from the library (see figure 20 on
page 28):
a
Grip the load pack handles and squeeze them together.
This releases the latches securing the load pack.
b
Still holding the load pack handles, pull the load pack forward
and out of the library.
c
Repeat steps 2a and 2b to remove the bulk pack.
3
Set both packs aside.
4
Reaching in through the front doors of the library, insert a tape
cartridge into each of the nine storage bins above the tape drives.
(See figure 25 for the correct tape cartridge orientation.)
Each cartridge should slide into place with very little force. If a
cartridge does not slide into place easily, check the cartridge for
correct orientation and structural integrity.
Figure 25 Correct Tape
Cartridge Orientation
5
Insert a cartridge into each of the five storage bins above and
below the load port at the front of the library.
This requires you to reach into the library through the front doors
and then back toward the front. There are four bins above the load
port and one bin below.
6
Verify that each cartridge is properly seated in the bin (see
figure 25 for correct cartridge orientation).
Insertion arrow
Bar code label
Write-protect switch