Quantum P1000 Series, Руководство пользователя

Страница: 102 / 132

Chapter 6 Troubleshooting
Start-up Problems
86 ATL P1000 Series User’s Guide
Start-up Problems
6
Table 9 provides corrective actions for problems which may occur
while starting up the library.
Table 9 Start-up Problems
Problem Corrective Action
The library does not power
on. Be sure the power switch is on and the
power cord is connected to a grounded
electrical outlet.
The library or tape drives do
not respond on the SCSI bus. Be sure each SCSI device on the same
SCSI bus has a unique address, and that
the last device is properly terminated.
The library reports are not
ready during initialization. Determine the failure type by checking
any previous error codes returned to the
host computer. Correct the cause of the
error.
One or more tape drives fail
to spin up during start-up. Check all SCSI cabling and termination on
the back panel of the library. If necessary,
contact your field service representative
about replacing the drive(s).
The gripper has a cartridge,
preventing system calibration
and inventory. Manually remove the cartridge from the
gripper, and then restart the library.
The library starts up in
standby mode. Press the Standby button. Verify that the
library switches to on-line.
The setting of the Power-On option
determines whether the library will be
on-line or off-line when it is powered up.
To change this setting, see “Configuring
Library Options” on page 62.