SCSI Commands: 40BREQUEST SENSE
Page
176
Sense
Key
Byte 2
ASC
Byte 12
ASCQ
Byte 13
Message
Explanation
04h 40h
85h
MON Task diagnostic
failed
During POST or diagnostics the
MON Task reported an error. Refer
to the VSCQ for more information
about the cause.
04h
40h
86h
LIB Task diagnostic failed
During POST or diagnostics the LIB
Task reported an error. Refer to the
VSCQ for more information about
the cause.
04h 40h
87h
CHANNEL Task
diagnostic failed
During POST or diagnostics the
CHANNEL Task reported an error.
Refer to the VSCQ for more
information about the cause.
04h
40h
88h
LED Task diagnostic failed
During POST or diagnostics the
LED Task reported an error. Refer
to the VSCQ for more information
about the cause.
04h 40h
90h
SERVO Task FAN
diagnostic failed
During POST or diagnostics the
SERVO Task reported a FAN error.
Refer to the VSCQ for more
information about the cause.
04h 40h
91h
SERVO Task diagnostic
failed
During POST or diagnostics the
SERVO Task reported an error.
Refer to the VSCQ for more
information about the cause.
04h
40h
BDh
Diagnostic task timeout
Task failed to respond to diagnostic
request.
04h
44h
00h
Internal target failure
Hardware error occurred.
04h 44h
D3h
AIC interrupt read parity
error
SCSI chip internal parity error
detected.
04h
52h
00h
Cartridge fault
The tape is snapped.
05h Illegal Request
05h
1Ah
00h
Parameter list length error
The amount of data sent in a MODE
SELECT or LOG SELECT com-
mand is incorrect.
05h 20h
00h
Invalid command
operation code
The Operation Code in the
command was not a valid Operation
Code.
05h
24h
00h
Invalid field in CDB
An invalid field has been detected in
a Command Descriptor Block.
05h
25h
00h
Logical unit not supported
The command was addressed to a
non-existent logical unit number.
05h 26h
00h
Invalid field in parameter
list
An invalid field has been detected in
the data sent during the data phase.
05h
26h
02h
Parameter value invalid
Firmware download flash failure.
05h 26h
04h
Invalid release of
persistent reservation
Invalid request for release of a
Persistent Reservation.
05h 26h
98h
Invalid field parameter
checksum
Microcode image invalid, bad
checksum or CRC.
05h 3Bh
0Ch
Position past beginning of
medium
SET CAPACITY command issued
with tape not at beginning-of-
medium.
05h 53h
02h
Medium removal
prevented
An UNLOAD command has failed to
eject the tape because medium
removal has been prevented.
Содержание LTO 4
Страница 1: ......