Chapter 9: Configuration
System
Quantum DXi4700 User’s Guide
334
1. Select the
Enable Redirect Logging
check box.
2. Enter the following information about the redirect:
Redirect Logging Target
Enter the
Hostname
or
IP Address
of the system where the logs will be
redirected.
Port
Enter the
Network Port
number. The default port is 514.
Protocol
Select the network protocol:
l
UDP
- User Datagram Protocol (Default)
l
TCP
- Transmission Control Protocol
3. Click
Apply
.
FC Initiators and Targets
The
FC Initiators & Targets
page allows you to see all path to tape initiator and target ports and their
associated World Wide Port Numbers (WWPNs). You can also change a Fibre Channel port to initiator or
target mode.
Note:
Fibre Channel ports are available in DXi4700 VTL and Multi-Protocol configurations only.
To access the
FC Initiators & Targets
page, on the
System
page, click the
FC Initiators & Targets
tab
).
Figure 217:
FC Initiators and Targets Page
Tasks
Use the
FC Initiators & Targets
page to perform the following tasks:
View information about initiator and target Fibre Channel ports (see
Fibre Channel Initiators and Targets
).
Change the mode of a Fibre Channel port (see
Editing the Fibre Channel Port Type on the next page
).
