Chapter 9: Configuration
System
Quantum DXi4700 User’s Guide
290
To send a test SNMP trap, select a destination in the list and click
Send
. If the destination does not receive
the SNMP trap, make sure that the destination IP address is correct (see
). Also make sure that the community information is correct (see
).
System
The
System
page allows you to configure system settings for the DXi4700, including network settings,
system date and time, and security settings.
To access the
System
page, click the
Configuration
menu, and then click the
System
tab.
The
System
page contains the following tabs:
l
l
l
l
l
l
l
l
FC Initiators and Targets on page 334
Network
The
Network
page allows you to view and change network configuration information for the DXi4700. The
DXi4700 uses this information to connect to the network.
Network configuration information is entered during initial setup DXi4700. You should consult your network
administrator before making any changes to the network settings.
Caution:
Changing the network configuration requires a system reboot to allow all system services to
function correctly. Changing the network configuration requires a system reboot immediately after the
changes are applied.
To access the
Network
page, on the
System
page, click the
Network
tab.
Configuring the Network
Using the
Network
page, each physical Ethernet port in the DXi can be configured as a separate device. In
addition, you can create bonded devices (logical ports) consisting of two or more physical ports of the same
