Chapter 9: Configuration
VTL Configuration
Quantum DXi4700 User’s Guide
226
Remote Host
Select the host (initiator) to associate with the group.
Note:
You must configure a host before it is available in the
Host
drop-down box
).
Target
Select the target (port) to associate with the group.
The
Backpanel Locations
section displays a graphical representation of the Fibre
Channel and Ethernet ports as they appear on the rear of the system. A dark border
displays around the currently selected target.
Note:
If a target is directly connected to the DXi, only the directly connected ports
are displayed. Otherwise, all ports are displayed.
3. (Optional) Select the
Use CCL
check box to use the Command and Control LUN.
Note:
The CCL (Command and Control LUN) is not used in most environments. This option is
recommended for host access groups that contain an HP-UX host. It can also be used if hosts that
are not assigned to any host access group exist in the SAN. The CCL is accessible to hosts only
through LUN 0.
Caution:
If you are not sure if you should use CCL, contact Quantum Customer Support before
you enable this option.
4. Select the check boxes for the media changer and tape drives to add to the host access group.
The LUN assignment displays next to the device.
Drive Selection Helper
If there are more than 10 drives in the partition, the drive selection helper appears (see
).
Drives in the partition can be batch selected by specifying the
First Drive
,
Last Drive
, and
Starting LUN Numbers
. When a range of drives is selected, all other drives become unchecked
regardless of their current state.
Note:
Generated LUN numbers are sequential and must stay in the 0 to 255 range.
