quadient AS-850, Руководство пользователя

Страница: 15 / 86

SECTION 3
OPERATING PRINTER
15
Foil Torn
SECTION 3
– Operating Printer
Install Inkjet Cartridges (Printheads)
Printer can accommodate up to eight Proprietary EASYInk Cartridges.
See the section titled “Supplies - Compatible Inkjet Cartridges” for a list of compatible inkjet cartridges.
See the section titled
“Solvent Ink Cartridge Use & Care”
for guidelines on using Solvent Inks.
To install Cartridges:
1. Wear protective gloves, for safe handling of ink cartridges.
2.
Remove new Inkjet Cartridge from packaging.
Remove protective tape or clip from Cartridge Nozzle Plate.
Take care not to touch Cartridge contacts or Nozzle Plate with bare
hands.
3. Clean Cartridge nozzles (Nozzle Plate) as described in the appropriate
section for the type of ink (solvent or water-based) that you are using.
See sections titled
“Ink Cartridge Care – Water Based Ink”
and
“Solvent
Ink Cartridge Use & Care”.
4. Open Latch Lever fully. TIP : You may need to move Print Unit away
from sidewall of printer to allow room for Latch Lever to open fully.
5. With Cartridge Nozzle Plate pointing down, gently place Cartridge into
Pen Stall with cartridge as up-right as possible.
6. Push down, gently, on Cartridge until it bottoms out in Pen Stall.
Do NOT push Cartridge towards Latch.
7. Carefully Close Latch Lever – to secure Cartridge.
The Latch Lever is designed to swing the cartridge
into proper alignment with the pogo-pins
(contacts) as it is closed.
DO NOT
force Latch Lever closed.
TIP : Opening and Closing Latch may fix a contact
problem between pogo-pins and cartridge
contacts, due to misalignment.
8. Repeat the above Steps for remaining Cartridges.
CAUTION
For continued protection against possible fire, use only authorized Ink Cartridges.
40mL max ink for each cartridge. Flashpoint shall be > 93.3C per Material Safety Data Sheet.
CAUTION
Damage to Ink Carriage and or electronics can occur if you insert or
remove Cartridge at too steep of an angle. Cartridge foil may be
damaged/torn by strong contact with pogo-pins, within Pen Stall,
during install/removal of Cartridge.