quadient AS-850, Руководство пользователя

Страница: 12 / 86

SECTION 2
INSTALLING PRINTER
12
Positioning the Optional Feeder
A number of different Feeder models can be used with the AS-850.
The suggested feeder is the AS-FDR14 (EasyFeed 140) with RS-140 Feeder Stand, as shown below.
Place the AS-FDR14 Feeder onto the RS-140 Feeder Stand and position it at the input side of the Printer, as shown
below.
Connecting the Optional Feeder to the Printer
An appropriate Feeder Interface Cable must be attached between the printer and feeder, as shown below, so that
the printer can stop/start the feeder appropriately.
The feeder interface does NOT control feeder speed. The operator must manually adjust the speed of the feeder to
be slower than the printers transport speed. A gap of approximately one inch or more should be present, between
each piece of media as it feeds under the print units. If the speed of the feeder is set too fast, media will over-lap
as it feeds and cause jams in the printer.
Please use the appropriate cable (listed below) to connect the printer to your feeder.
FEEDER INTERFACE CABLES
PART # DESCRIPTION
*97E-500-193 AS-FDR14 (EasyFeed 140) Feeder to AS-850 Printer
35E-500-196 AS-FDR14 (EasyFeed 140) Feeder to TA-20/25 (T-750/650) Tabber, and AS-850 Printer
35E-500-194 AS-FDR14 (EasyFeed 140) Feeder to TA-30 (T-950) Tabber and AS-850 Printer.
* Cable included with printer.
NOTICE:
The above Feeder Interface Cables were originally made for use with the AS-980 (Envelope Imager XT3.0)
printer and FDR12 (EasyFeed 120) feeder, so they may be tagged as such. However, the above cables are also
compatible for use with the AS-850 printer and AS-FDR14 (EasyFeed 140) feeder.
Printer Connection Feeder Connection