Qlogic Storage Networking (Unified Fabric Pilot), Руководство по установке

Страница: 31 / 76

51031-00 A 5-1
5
Validation Methods for DCB
and FCoE
Validation Step 1—Verify PFC and ETS
Parameters
Verify the interoperability of the unified fabric devices by capturing the DCBX
exchanges between the QLogic initiator and each target.
The key parameters to verify are:

DCBX version used by each network component

Priorities assigned to each protocol

Priorities with the per PFC enabled

Bandwidth assigned to each priority
Validation Process
1. Place the Analyzer into the two paths shown as in Figure 5-1 .
Figure 5-1. Setup for Validating Unified Fabric
2. Configure the two Analyzer port pairs to be in the same time domain to
monitor DCBX exchanges between the two links.
3. Configure the Analyzer TraceControl to capture LLDP frames ( Figure 5-2 ):
4Gbps
10Gbps