8–Using QLogic Control Suite
Configuring Teaming
137
83840-546-00 D
11.
Select the probe interval (the number of seconds between each
retransmission of a link packet to the probe target) and the maximum
number of probe retries (the number of consecutively missed responses
from a probe target before a failover is triggered).
12.
Set the Probe VLAN ID to allow for connectivity with probe targets residing
on a tagged VLAN. The number set must match the VLAN ID of the probe
targets and the port(s) on the switch to which the team is connected.
13.
Click the probe target at the top of the list, click
Edit Target IP Address
,
type the target IP address in the
IP Address
box for one or all probe targets,
and then click
OK
. Click
Next
.
14.
Select a listed team member, click
Edit Member IP Address
, and then type
the member IP address in the IP Address box. Repeat for all listed team
members and then click
OK
. Click
Next
.
NOTE
Each LiveLink enabled team can only communicate with Probe Targets
on a single VLAN. Also, VLAN ID 0 is equivalent to an untagged
network. If the Probe VLAN ID is set to a value other than 0, then a
VLAN must be created with an identical VLAN tag value (see
NOTE
Only the first probe target is required. You can specify up to three
additional probe targets to serve as backups by assigning IP
addresses to the other probe targets.
NOTE
All of the member IP addresses must be in the same subnet as the
subnet of the probe targets.
