PURSUIT 3070 EXPRESS, Руководство пользователя

Страница: 52 / 167

3070 OFFSHORE
52
Check all below deck wiring to be sure it is properly supported, that the insulation is sound, and
that there are no loose or corroded terminals. Corroded terminals should be thoroughly cleaned
with sandpaper, or replaced, tightened securely and sprayed with a metal and electrical protector.
Inspect all engine wiring.
Check the electrolyte level in the batteries regularly and add distilled water as necessary. If the
batteries are frequently charged by the automatic battery charger, the electrolyte level will have to
be checked more often. The correct fluid level in the cells is usually approximately 1/4 to 1/2 inch
above the plates. If fluid is needed, fill to the proper level with distilled water. Do not over fill!
Please note that some batteries are sealed and cannot be filled.
Keep the battery tops clean and dry. Dirt and water can conduct electricity from one post to the
other causing the battery to discharge.
The battery posts should be kept free of corrosion. Remove the cables and clean the posts and cable
clamps with a battery post cleaner or sandpaper as required. Coating the battery posts and cable
clamps with petroleum jelly or silicone grease will protect them and reduce corrosion. Battery
cables, both hot and ground, must be replaced when they show signs of corrosion or fraying.
Deteriorated cables cause a considerable voltage loss when high currents are drawn, as for starting
the engine.
NEVER USE AN OPEN FLAME IN THE BATTERY STORAGE AREA. AVOID
STRIKING SPARKS NEAR THE BATTERY. A BATTERY CAN EXPLODE IF
A FLAME OR SPARK IGNITES THE HYDROGEN GAS THE BATTERY EMITS
WHILE BEING CHARGED.
AC Electrical System Maintenance
Periodically inspect all wiring for nicks, chafing, brittleness, improper support, etc. Examine the
shore power cord closely for cracks in the insulation and corrosion in electrical connectors.
Spraying receptacles and electrical connections with an electrical contact cleaner or a metal and
electrical protector will reduce corrosion and improve electrical continuity.
Inspect all wiring for proper support, sound insulation, and tight terminals, paying particular
attention to portable appliance cords and plugs.
The entire AC circuitry, especially the shore power cord, should be seasonally tested for proper
continuity by an experienced electrician. This will detect any shorts, open wires, or ground faults.
Ground fault interrupters should be tested periodically to ensure proper operation by pressing the
test/reset buttons in the center of the face plate. The polarity indicator system also should be
inspected for proper operation.
The engine maintenance required on the generator is similar in many ways to primary inboard
engines. The most important factors to the generator's longevity are proper ventilation, mainte-
nance of the fuel system, ignition system, cooling system, lubrication system and the AC alternator.