PURSUIT 3070 EXPRESS, Руководство пользователя

Страница: 51 / 167

3070 OFFSHORE
51
Additional AC Breaker Panels
Shore Power Inlet
Located in the cockpit near the shore power inlet plug. This breaker protects the AC system
between the shore power inlet plug and the main AC panel.
AC Power Selector Switch
The AC breaker panel will be equipped with this switch if the optional AC generator has been
installed in your boat. Move the selector switch to the “SHORE” position when connected to dock
side power. Move the selector switch to the “OFF” position when disconnecting the dock side
power or when no AC power is being supplied. Move the selector switch to the “GENERATOR”
position when the generator is being operated.
Generator Operation Panel
These switches control the starting, running, and stopping of the optional generator. The
procedures may vary depending on the model and type of generator installed in your boat. An
owner operator’s manual for the generator has been supplied with this manual. Please refer to it
for details on the generator operation.
Note: Gasoline generators charge the battery just enough to compensate for the DC
electrical current the engine requires to operate. Therefore, it is important to activate
the battery charger to maintain the house battery whenever the generator is running.
GENERATOR ENGINES PRODUCE CARBON MONOXIDE WHICH IS A LE-
THAL, TOXIC GAS THAT IS COLORLESS AND ODORLESS. IT IS A DAN-
GEROUS GAS THAT WILL CAUSE DEATH IN CERTAIN LEVELS. ONLY
OPERATE THE GENERATOR IN WELL VENTILATED AREAS AND NEVER
OPERATE THE GENERATOR WHILE YOU ARE SLEEPING.
4.4 Electrical System Maintenance
12-Volt DC Electrical System Maintenance
At least once a year, spray all exposed electrical components behind the helm and in the plugs, with
a protector. Exterior light fixture bulbs should be removed and the metal contact areas coated with
a non-water soluble lubricant like petroleum jelly or silicone grease. The sockets should be sprayed
with a protector. Care must be taken not to get any oil or petroleum jelly on the glass portion of
the bulbs as this will cause the bulb to overheat and burn out.
WHEN REPLACING LIGHT BULBS IN MARINE LIGHT FIXTURES, ALWAYS
USE A BULB WITH THE SAME RATING AS THE ORIGINAL. USING A DIF-
FERENT BULB COULD CAUSE THE FIXTURE TO OVERHEAT AND MELT
OR SHORT CIRCUIT.