PURSUIT 2865 DENALI, Руководство пользователя

Страница: 59 / 175

2865 DENALI
DAMAGE TO THE PUMP WILL RESULT.
6.3 Livewell
Sea water is provided to the livewell by a 12-volt
circulation pump. This pump is designed to carry a
constant flow of water to the livewell. The pump is
not equipped with a pressure sensor and is activated
by the livewell switch located in the cockpit below the
port gunnel. If there is a light in the livewell, it is also
activated by the livewell switch.
An overflow built into the livewell automatically
controls the water level in the livewell. Always turn
the pump off at the switch panel when the livewell is
not in use.
To fill the livewell, insert the plug into the drain fitting
at the bottom of the livewell. Make sure the valve in
the intake thru hull fitting is open and activate the
livewell switch. When the water level reaches the
overflow, it will automatically be regulated.
To drain the livewell, turn off the livewell pump and
pull out the plug in the drain fitting at the bottom of the
livewell. When the livewell has completely drained,
use the washdown hose to flush the livewell and drain
of debris.
The livewell supply thru hull valve should be closed whenever the livewell is not in use. This
will prevent water from entering the livewell while the boat is cruising.
The livewell system is equipped with a sea strainer on the intake side of the pump located in
the bilge behind the stern access hatch. This should be checked frequently and cleaned as
necessary.
Notice: Do not use the livewell as a dry storage area when it is not in use. Sea water could
accidently be delivered to the livewell from the thru hull fitting and damage
equipment stored there.
ALWAYS TURN THE LIVEWELL PUMP SWITCH TO THE “OFF” POSITION
WHEN LEAVING THE BOAT UNATTENDED.
Livewell
6-3