21
PROMAG
STARMIX 60W - E60W - 60A - E60A - 120W - E120W
USER INSTRUCTIONS
GB
Do not permit machine to be used by children or
inexperienced persons.
Machine must not be used by untrained personnel.
Maintain machine in perfect operating condition, always
utilizing the various protections provided for, having
periodical maintenance carried out by professionally
qualified personnel.
In particular it is recommended to have same periodically
control the functioning of all security devices.
Before connecting the machine, control that plate data
corresponds to that of electric and water distribution
network, (the plate is situated at the rear part of the
machine).
Assure that machine is perfectly grounded, as foreseen
by safety regulations in force.
It is necessary that this fundamental safety requisite is
respected: in the case of doubt, ask for a careful control
of the plant by professionally qualified people.
Check that plant electric power is adequate for the
maximum absorbed power of the machine.
In case of doubt, revert to a qualified person, who must
control that the plant cable section is adequate for the
power absorbed by machine.
- Do not touch the machine with either wet or damp
hands or feet
- Do not use the machine barefoot
- Do not use extensions in rooms destined for
bathrooms or shower rooms
- Do not pull the feed cable to disconnect the machine
from mains.
In order to avoid dangerous overheating, it is necessary
to wind up the entire feed cable.
Before carrying out any maintenance operation,
disconnect machine from mains, using plant
disconnecting device
.
In case of breakdown and/or poor functioning of
machine, disconnect the main disconnecting device,
abstaining from any attempt to repair or intervene
directly, reverting only to professionally qualified and
authorized personnel.
Eventual product repair will have to be carried out
by manufacturing company or by an authorized
Service Centre, only using original spare parts.
Machine safety could be compromised, if above
instructions are not observed.
Never utilize water to turn out fires occurring on
electric parts, but a dry powder fire extinguisher.
The machine must be turned off when not in use.
Do not modify protections and remove them only
when machine is no longer operative and
disconnected from mains.
Should you decide to no longer use this type of
machine, disconnect same by removing feed cable
from mains.
Discharge tubing must be resistant to a continuous
temperature of 50° C.
For cleaning operations, scrupulously follow
instructions laid down by manufacturer.
Do not block suction or dissipation grilles.
After having disconnected the machine, only qualified
personnel may have access to control panel.
When washing stainless steel, it is absolutely
forbidden to use steel shavings, wool or brushes.
For protection of environment and machine itself,
please abstain from using corrosive or polluting
products, taking care not to exceed quantities
advised.
