20
PROMAG
STARMIX 60W - E60W - 60A - E60A - 120W - E120W
USER INSTRUCTIONS
GB
A 16 - RECOMMENDATIONS ON PREVENTION MEASURES TO BE ADOPTED
A 16.1
Safety regulations.
In order to maintain the machine in perfect condition
and guarantee a safe operation for user, we advise that
following regulations are scrupulously followed.
This machine must only be used for the purpose for
which it has been originally designed.
Any other use is to be considered improper and therefore
dangerous.
During handling, loading and unloading of machine, be
very careful in choosing lifting points.
Do not leave machine exposed to atmospheric agents
(rain, sun, etc.).
A 15.4
Danger of cutting, entangling and crushing
During the washing and cleaning operations, the rear
half-cover shall be lifted and put in a 30° position of
opening in vertical position.
As already mentioned, there is no danger of same
falling frontwards as gravity centre of the ìrear half-
lid, emulsioner motor, mixer motor and hingeî group
is orientated towards external part of machine.
The danger could exist either if the floor is uneven of
very inclined, or if during the rear half-cover a sudden
jerk was given making it coming back in the frontal
direction out of inertia. This could cause squasing,
cutting and entagling between the rear half-cover and
the edge of the tank, as well as the tank surface.
It is absolutely forbidden to have the rear half-cover
opened by UNEXPERIENCED PERSONNELL.
It is absolutely forbidden to place the machine in an
environment unsuitable for its correct use.
It is absolutely forbidden to move the machine and/
or its components in a sharp manner, thereby
jeopardizing its stability and reliability.
In case of danger, push the STOP button (
29
).
Danger also exists when approaching the machine
with magnetic materials (especially with rear half-lid
open), as same would interfere with safety magnetic
microswitches (
63
) located under the two cylinder
half-lids.
In this case, if the machine were operating, the two
motors would start up, causing the respective shafts
to rotate, dragging anything in contact around with
them.
It is absolutely forbidden to approach the machine with
magnetic materials or interfere with safety magnetic
switches on purpose.
In case of danger, press the STOP button (
29
).
A 15.5
Dangerous electric voltage
During repair and/or maintenance operations,
(operations nevertheless permitted only by qualified
personnel, authorized by Promag), it is possible that
technician needs access to control board, motor-driven
compressor, motors or any other electric or
electromechanical component.
Danger exists if these operations are carried out without
having previously cut off electricity from mains, using a
special disconnecting device provided for during
machine installation, or even worse, when the machine
is in operation.
It is absolutely forbidden to gain access to electric and/
or electromechanical parts, without having previously
turned off machine with special disconnecting device.
In case of danger, press the STOP button (
29
).