3302C Series Mainframe Operation Manual 2-1
Chapter 2 Installation
2.1 Inspection
The 3302C mainframe was carefully inspected before shipment. If instrument
damage has occurred during transport, please inform Prodigit's sales and service
office or representative.
Your 3302C mainframe was shipped with a power cord for the type of outlet used at
your location. If the appropriated cord was not included, please contact your
nearest Prodigit sales office to obtain the correct cord. Refer to " check line voltage
" to check the line voltage selection and fuse type.
2.2 Check line voltage
The 3302C mainframe and 3250A/3310A/3310C/3330A/3320 series electronic load
can operation with 100, 115, 200, 230Vac input as indicated on the label on the
rear panel.
Make sure that the factory check marks correspond to your nominal line voltage.
Skip this procedure if the label is corrected marked.
2.2.1 With the 3302C mainframe power OFF, disconnect the power cord.
2.2.2 Refer the drawing on the rear panel in Fig 2-1, set the switches to the proper
voltage as describe in the following:
a. Set Switch to 100V/115V for 100Vac or 115Vac line voltage
b. Set Switch to 200V/230V for 200Vac or 230Vac
Note: 100Vac and 200Vac is used for Japan only
Fig 2-1 SET OF SWITCH
