3-4 PRODIGIT
3.3.3 RECALL operation:
3.3.3.1 For 3250A and 3310A series, press one of the Memory State 1
through 5 key, the appropriate LED annunciator will be lit, the
store state on the 3302C mainframe is sending to the electronic
load module simultaneously. Before press the states key, you
press any key on the load module then the state LED annunciator
is blank immediately, it indicates the STORE state has been
changed on load module's front panel.
3.3.3.2 For 3310C and 3330A series, using UP and Down key to select
the Memory Bank, then follow the procedure (a.) for the Memory
Recall operation.
3.4 AUTO SEQUENCE testing function description
There are two modes in AUTO SEQUENCE function, EDIT MODE and TEST
MODE, The AUTO SEQ mode can be entered by press S3 + S4 key
simultaneously, then press STORE key again to enter the EDIT MODE, or press
START key to enter the TEST MODE, Please refer to the flow chart operation
below:
Normal Mode
AUTO SEQ.
Press S3+S4 key
Display bank no.
Press Exit key
bn
Show r1-r9
Display 3300C Firmware version r1-r9
Display bank
STATE MODE
STORE MODE
Press STATE key
Press STORE key
Show n1~n9
Fig 3-3 AUTO SEQUENCY FUNCTION OPERATION FLOW-CHART
3.4.1 EDIT MODE
The TEST Mode of Auto-Sequence function is entered by press S3 + S4 key
simultaneously, The EDIT mode of Auto Sequence function is entered by
press S3 + S4 key simultaneously, the S3 and S4 LED are ON to indicate
Auto-sequence mode, then the Edit mode of Auto-sequence function is
proceed by press STORE key.
