TRAVELER 4all Ergo & 4you Ergo usage instructions
34
Figure 82: Wheelchair axis (view from the inner side
of the product)
Figure 83: Torque support pin mounted on the
product (view from outer side of product without
drive wheel)
To
attach the wheelbase extension
, pull the
actuating cable and hold it in this position.
Guide the front mouth underneath the wheel-
chair axle and insert this on both sides on the
"Pin torque support". Now lift the wheelbase
extension until the rear mouth surrounds both
sides of the wheelchair axle. The actuating
cable can then be released. Now the wheel-
base extension is fixed tight.
Figure 84: Wheelbase extension attached (view
from outer side of product without drive wheel)
Figure 85: Wheelbase extension attached (view
from the inner side of the product)
To
remove the wheelbase extension
, pull the
actuating cable and hold it in this position.
Release the rear mouth from the wheelchair
axle on both sides by moving the wheelbase
extension down slightly. Then pull the front
mouth from the "Pin torque support" on both
sides. The actuating cable can now be re-
leased.
For
changing the drive wheels
between the
wheelchair axle and the axle of the wheelbase
extension, proceed as described Chapter 22.1.
22.6 Other
If tyres, inner tubes or handrims need to be
replaced, please contact your rehabilitation
specialist retailer.
Recommended equipment:
The spoke guard prevents hands and fingers
entering and being trapped in the wheels when
riding. The risk of injury is thus minimised.
Figure 86: Spoke guard for minimising the risk of
hands and fingers getting trapped
Pin torque support
Front mouth on the
"Pin torque support"
Wheelchair axle
Rear mouth on the wheelchair axle
