TRAVELER 4all Ergo & 4you Ergo usage instructions
44
Note:
With a V-shaped product frame or with a larger
lower leg width at the top than the bottom, it is
necessary to relieve the footrest support tube
tension in the footrest support plate resulting
from length adjustment or to correct the shifted
position of the footplate support. The footplate
support can be moved back to the correct posi-
tion by opening the M6 fastening clamp screws
(AF 5 mm) on the footrest support plate. View
the procedure in Chapter 24.1.
24.5 Footrest folds up to the rear with
spring locking mechanism
Figure 117: Footrest, folding up to the rear, with
spring latching mechanism, in standard position
To
fold the footrest up to the rear
, the foot-
plate must be pushed gently backwards until
the footrest is released from the lock. Now the
footrest can be folded up completely to the
rear.
Figure 118: Footrest, folding up to the rear, with
spring latching mechanism, folded up to the rear
If you want to return the footrest to the stand-
ard position again, push it back forwards to the
standard position.
To
adjust the length of the footrest support
tubes or adapt the lower leg length
, the M6
fastening clamp screws (with polymer dry lock-
ing coating, AF 4 mm) must be unscrewed on
both outer sides of the lower leg tubes. The
lower leg length can now be adjusted along the
notches. Make sure that the same notch is
used on both sides.
A large adjustment range is available for a
shorter lower leg length. If a longer lower leg
length is desired, it can usually be extended by
2 cm with the existing lower leg tube. If a
greater extension is desired, longer lower leg
tubes can be obtained from PRO ACTIV.
Once the lower leg length is adjusted, fix it in
position by inserting the M6 fastening clamp
screws (with polymer dry locking coating, AF
4 mm) on both sides and tightening them to
7 Nm.
Figure 119: Notches and M6 fastening clamp screw
for lower leg length adjustment (view from the rear)
Note:
With a V-shaped product frame or with a larger
lower leg width at the top than the bottom and
footrest support tubes that do not run parallel,
it is necessary to relieve the footrest support
tube tension in the footrest support plate result-
ing from longitudinal adjustment. In this case,
the M6 fastening clamp screws (AF 5 mm) on
the footrest support plate therefore have to be
M6 fastening clamp
screw
Notches
