TRAVELER 4all Ergo & 4you Ergo usage instructions
25
Figure 45: Ergonomic back shell without back pad-
ding with Velcro cross-straps (view from the front)
To fold the product, the back shell must be
removed. To
remove the back shell
, pull the
release lever of the locking clamp upwards and
at the same time, press the back shell for-
wards.
Figure 46: Back shell locking clamp and release
lever (view from rear)
To
install the back shell
, it is pushed onto the
back tubes and guided into the plug-on mount
on the back joint on both sides. During this
procedure, pull the back shell towards the rear
so that the locking clamp of the back shell
engages on the back cross bar.
Figure 47: Back tubes and back cross bar
(view from rear)
Figure 48: Plug-on mount clamp for the back shell
(view from front)
20 Seat system
Avoid falling into the seating and backrest
upholstery/back shell as it significantly in-
creases the risk of an adjustment, falling down
or defects.
The seat system generally consists of a belt
system. This can be adjusted subsequently.
Using the fleece hook-and-loop straps, the
slack in the seating surface can be changed so
that it suits your seat cushion system. In doing
so, the seat cover should not have too much
slack to avoid touching the folding mechanism.
Figure 49: Open belt system with fleece hook-and-
loop straps for adjusting the slack
Velcro cross-straps
Release lever for the locking clamp
Locking clamp for
the back shell
Plug-on mount clamp
for the back shell
Back cross bar
Back tubes
