Printronix Network Interface Card, Руководство пользователя

Страница: 196 / 378

Chapter 7
Troubleshooting (10/100Base-T)
196
•
Try a
debug nest pserver
telnet command (or find the
“PSERVER” section on the Novell HTML status page). Look for
a valid queue under the “EPS QUEUES” section. If the printer
field contains a number, and there is a valid file server but no
queue, then you probably made an error in the setup. At this
point try again. If it is an NDS PSERVER setup, look for a line
with the following type of message: “Could not login to NDS
Tree <TREE> as <PSERVER.<CONTEXT>”. This indicates
one of the following: the tree is wrong; the context stored on the
NIC for the print server object is wrong; the print server object
password is wrong; or the print server object name is wrong.
•
Try a
debug nest rprinter
telnet command (or find the
“RPRINTER” section on the Novell HTML status page). Look
for the following type of line: “(0:ENPReadConfig):[0:213]
Destination = <
X >”, where < X > is between 0 and 3. If they all
read: “Destination = 65536,” then the PSERVER setup did not
complete properly. If there was a valid queue under “EPS
QUEUES” in the
debug nest pserver
command, then the
printer name probably does not match an existing destination
name on the NIC, or Novell has been disabled for that
destination. If there is a valid “Destination =” line, then double
check that there is an entry for this number under the “ENP
INFO” section.
NOTE: Debug messages for the PSERVER setup are in the
RPRINTER section here because the PSERVER setup on
the NIC shares some code with the RPRINTER setup.
•
Try a
debug nest logs
telnet command (or find the “General
Messages” section on the Novell HTML status page). Look for
a valid entry for the printer. It will look something like this:
“(0:InitSinglePrinter): printer=<
X > name=<NAME>”. Then look
for the following lines: “(0:Printf): RemoteMonitor(< X >); printer
is” and “(0:Printf): WAITING_FOR_JOB”. If you see these lines,
the NIC is set up properly, and the problem points to a setup
issue on the workstation.