Primera Impressa 2, Руководство пользователя

Страница: 92 / 104

The On-Line LED light under the Printer controls is flashing rapidly.
This indicates an error has occurred with the print media or with the print ribbon.
If such an error occurs before the digital press actually starts to print, the error is
recoverable. Correct the problem and press the On-Line button to resume printing.
If the error occurs after the digital press starts printing, select the Cancel Print
button in the 32-Bit Print Spooler to cancel the print job, and correct the problem.
Then, press the printerÕs Cancel button to clear its memory, and resend the print
job. If necessary, you can also reset the printer by simultaneously pressing the
CutterÕs Cancel and Pause buttons or by simply turning the unitÕs power OFF and
ON (see Section 3-D for more information on the button functions). Note that if the
32-Bit Print SpoolerÕs
Save last job for reprint option was selected, you simply
have to select the spoolerÕs
Print
button to resend the job. Refer to the following list
for possible causes to this printer error condition.
■
Check that you have properly loaded print media and a print ribbon and that
you have not run out of either. Replace media as required (see Section 4).
■
Make sure the Ribbon Type option selected in the printer driver matches the
type of ribbon currently installed. (see Section 6-D for Ribbon Type
information).
■
Check that you have loaded compatible print supplies according to the
descriptions given in Section 4. Remember, only supplies within the same #100,
#200, or #300-Series can be used with one another.
■
Check to see if the print media is jammed or is not feeding effectively from the
Media Supply Tray. If jammed, clear according to Section 8-H. If not feeding,
separate the print media to assure it is not sticking together. Also, be sure the
Media Supply TrayÕs In-Feed Clutch is set properly according to Section 4-H.
You may also need to clean the In-Feed Rollers according to Section 8-F.
■
Check to see if the ribbon is jammed down into the Platen Roller. If so, clear the
jam according to Section 8-G.
■
If you have removed the Print Pressure Bracket according to the instructions in
Section 8-I, be sure it was re-installed properly according to these same
instructions.
Section 9: Troubleshooting 87
Digital Label and Decal Press 2 UserÕs Manual
DLDP2.qxd 3/29/99 9:56 AM Page 87