Primera Impressa 2, Руководство пользователя

Страница: 86 / 104

Section 8: Maintenance 81
Digital Label and Decal Press 2 UserÕs Manual
K. REPLACING THE CUTTER BLADE
The cutter uses a tiny razor-sharp blade to kiss-cut its output. Over time, this blade
will eventually begin to grow dull. When this happens, you may notice one or all of
the following symptoms:
■
The cut line is rough or jagged as if the media were being ripped instead of
sliced.
■
If the cut line has sharp, pointed corners, some of these corners start to lift up
as they are cut.
■
Excess cutting pressure is required for print media which originally required
far less pressure.
■
Print media which normally cuts fine, starts to stall the cutter as cut pressure is
increased.
If any of these symptoms begin to consistently occur, replace the Cutter Blade
according to the following steps.
1. Open the Cutter Door by pulling down on the doorÕs handle.
2. Locate the black, plastic Cutter Arm which holds the aluminum Blade Holder
in place.
3. Loosen the gold-colored Securing Knob by turning it toward the rear of the
printer.
Cutter Arm
Blade Holder
Securing Knob
DLDP2.qxd 3/29/99 9:56 AM Page 81