Powerware BPIV 15 kVA, Руководство по установке и эксплуатации

Страница: 70 / 104

DESCRIPTION:
DATE:
DRAWING NO:
1 of 11
SHEET:
REVISION:
B
NOTE:
Callout letter
and
map to drawing #164201409---5
, ,
101503
A
B
C
164201409---1
POWER WIRING INSTALLATION NOTES
A---2
Powerware BPIV Parallel Cabinet Installation and Operation
164201409 REV. B 101503
Table A. INPUT/OUTPUT Ratings & External Wiring Requirements for
Powerware BPIV---15 Parallel Cabinet
(1 + 1 Configuration)
Ratings
Units Rating 50/60 Hz
Basic unit ratings at
0 7 l i PF l d
UPM KVA 15 g
0.7 lagging PF load
INPUT/OUTPUT
VOLTAGE
208
AC Input from UPM (0 7PF)
Amps 41 6
AC Input from UPM (0.7PF)
3 (1) N l (1) d
Amps 41.6
AC
INPUT
p ( )
3 , (1) Neutral, (1) gnd
Minimum conductor size (number per )
AWG or kcmil(ea)
Refer to Powerware BPIV
UPS Installation and
Operation manual for
wire size.
(Input current and wiring size is for each module)
AC
AC Input to Bypass (UPM Bypass)
Full Load Current
3 , (1) Neutral, (1) gnd
Amps
41.6
AC
INPUT
Full Load Current
3 , (1) Neutral, (1) gnd
Minimum conductor size (number per )
AWG or kcmil(ea) 6 (1)
AC
AC Output to Critical Load
Full Load Current 3 (1) Neutral (1) gnd
Amps 41.6
AC
OUTPUT
Full Load Current 3 , (1) Neutral, (1) gnd
Minimum conductor size (number per
)
AWG or kcmil(ea) 6 (1)
Read and understand the following notes while planning your installation:
1.
Refer to national and local electrical codes for acceptable external wiring practices.
2.
The bypass feed into this equipment utilizes four wires.
3.
Material and labor for external wiring requirements are to be provided by designated
personnel.
4.
For external wiring, use 90
°
C copper wire. See the appropriate column in Tables A
through J.
5.
Wire ampacities are chosen from Table 310---16 of the NEC.
6.
Wire sizes computed for a 40
°
C ambient temperature and a single neutral wire.
7.
Refer to Section I of this manual for installation Instructions.
8.
UPM bypass and Parallel Cabinet bypass input feeds must come from the same source.
9.
UPM disconnect switches must be wired in order starting with UPM 1 (e.g., UPM 1 wired to
UPM disconnect switch 1).