Power One Aurora PVI-10.0-I-OUTD-400, Инструкция по установке и эксплуатации

Страница: 53 / 395

Use and installation manual Page
52
of
97
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
5.4 Messages and error codes
The system status will be identified by message or error signals, shown on the
LCD display.
The tables below summarized the two types of signals which may be displayed.
The MESSAGES indicate AURORA current status, they do not caused by faults,
and do not involve any action; the messages will disappear once normal conditions
are re-established. See the W lines in the following table.
ALARMS indicate a possible fault in the equipment or connected parts. The signal
will disappear once causes are removed, except in the case of ground isolation
problems, for which qualified personnel will have to be called in order to have the
system restored to normal operation. The appearance of an error signal generally
involves some form of action, which will be managed by AURORA as far as
possible; when this is not possible, AURORA will supply as much helpful
information as possible to those performing the necessary maintenance on the
equipment or system. See the E line in the following tables.
Message Error warning Error
type
Description
Sun Low W001 // Input Voltage under threshold
Input voltage under threshold (in OFF
status)
Input OC // E001 Input Overcurrent
Input UV W002 // Input Undervoltage
Input OV // E002 Input Overvoltage
Int.Error // E003 No parameters
No parameters
Bulk OV // E004 Bulk Overvoltage
Int.Error // E005 Internal Communication Error
Communication error on internal bus
Out OC // E006 Output Overcurrent
Int. Error // E007 IGBT Sat
Bulk UV W011 // Bulk Undervoltage
Int Error // E009 Internal Error
Internal error
Grid Fail W003 // Grid Fail
Grid out of range
Int.Error // E010 Bulk Low
Int.Error // E011 Ramp Fail