LECOASPIRA INTELLIGENT 2.0
167
ENGLISH
GLASS/MIRRORS/SHOWER CUBICLE
STEAM-VACUUM FUNCTION
To dissolve deposited scale, remove grease, polish and remove smears.
To clean glass surfaces in particularly cold seasons, preheat the windows starting from a
distance of about 50 cm) from the surface.
MANUAL MODE
PROGRAMMED MODE
After turning on the boiler, by following the
instructions listed in the paragraph “SET THE
STEAM LEVEL IN MANUAL MODE”, set the
steam pressure on Level 2.
Press the button (
A5
) on the handle to dispen-
se steam over the surface to be cleaned.
To stop the steam flow, simply release the but-
ton (
A5
).
Then activate suction by means of the button
(
A4
) to dry the surface treated.
Holding the button (
A4
) down, select the desi-
red suction speed, see paragraph “SET THE
SUCTION LEVEL IN MANUAL MODE”.
PROGRAMME P3
Set the P3 programme described in the paragraph
“TO USE THE APPLIANCE WITH THE PRE-SET
PROGRAMMES”. Start the programme by pres-
sing and holding down the steam supply button
(
A5
) to start pouring steam on the surface to be
treated. Direct plenty of steam on the surface to be
treated. When releasing the button (
A5
) or after a
maximum of 30 seconds, the suction starts auto-
matically.
IF YOU NEED TO RESTART THE PROGRAMME
TO COMPLETE CLEANING THE ENTIRE SUR-
FACE, JUST HOLD THE BUTTON (
A5
) DOWN
AGAIN.
In any case, it is possible to stop the programme
manually by pressing the suction button (
A4
).
N.B. If the surface is very dirty, we recommend
vacuuming and washing deep-down, activating
both steam and suction simultaneously (there-
fore pressing button (
A5
) immediately followed
by button (
A4
). This will ensure that surfaces
are cleaned and dried in a single trip.
For best results, press the rubber window cleaning fitting against the surface to be dried, moving
from the top to the bottom.
LECOASPIRA INTELLIGENT vers. 2012_mod7:Layout 1
11/04/2012
8.49
Pagina 167
