LECOASPIRA INTELLIGENT 2.0
156
ENGLISH
To select a pre-set programme, press the SET key (
3
); when the indicator (
8A
) starts to flash, it is
possible to select the desired programme with the UP (
4
) and DOWN (
5
) keys. Press the OK (
2
)
key to confirm the selection.
The boiler turns on automatically in the 1 to 9 programmes. Wait until the indicators (
8B
) and (
8F
)
stay lit. This means that the steam pressure corresponds to the one necessary to use the pre-set
programme. The appliance is now ready to be used.
It will only be necessary to press the steam button (
A5
), except for the P0 programme which is suc-
tion only and starts by pressing the suction button (
A4
).
Based on the programme selected, there will be an alternating sequence of steam and suction.
N.B. In order to guarantee the maximum safety of the user, European Regulation 60335-2-54 envi-
sages that the supply of steam must occur in a voluntary manner. Because of this, when the pro-
grammes described were developed, it was not possible to automate the steam supply function.
7) CONNECTING THE ACCESSORIES
7.1) STEAM + SUCTION EXTENSION TUBES
To connect the two extension tubes together (
B
) and (
B1
) it is important to pay attention to the di-
rection indicated by the arrows. The appliance is in fact equipped with a parking system on which it
is possible, when you have finished using them, to replace the extension tube accessory (
B1
). In-
correct assembly of the two parts, (
B
) and (
B1
), will not allow this feature to be used.
Hook both extension tubes (
B)
and (
B1)
to the connecting accessories
(A1)
of the flexible hose
(A)
.
7.2)
TELESCOPIC SUCTION TUBE
The length of the telescopic suction tube can be adjusted from a minimum of 60 cm to a maximum
of 1 metre. To increase or decrease length, press the release button (
IA
) and extend or reduce
length as desired.
Then connect the telescopic suction tube (
I
) to the connecting accessories (
A1
) of the flexible hose
(
A
).
Warning - the telescopic suction tube can only be used in suction mode to vacuum liquids and so-
lids. Absolutely do NOT use in steam mode.
7.3) USE OF THE ACCESSORIES STORAGE
The accessories storage (
16
) allows you to fasten the tube (
B1
) with or without the brush assem-
bled onto the appliance body.
To connect the tube (
B1
) to the appliance, slide the hook located on the tube into the accessories
storage on the appliance (Fig. 9).
7.4) CONNECTING THE ACCESSORIES
All the EcoSteamVac accessories can be connected directly to the connecting accessories (A1) or
to the extension tubes
(B)
or
(B1)
, previously assembled (see paragraph 7.1).
To connect the specific accessories for the suction and steam features
(B-B1-C-D-E)
: proceed as
follows:
- Move the locknut
(B2)
of the accessory, if present, to the OPEN position (Fig.A1).
- Attach the desired accessory to the handle.
- Move the locknut
(B2)
of the accessory to the CLOSED position (Fig. A2)
LECOASPIRA INTELLIGENT vers. 2012_mod7:Layout 1
11/04/2012
8.49
Pagina 156
