1
4
3
2
5
6
7
8
PUM_SBT_091102_EN
17/38
8.
INSTALLATION
BACK VIEW
SIDE VIEW
SUSPENSION MOUNTING PROCEDURE
1.
SBT-profile
2.
Support leg
3.
Mounting clamp
4.
Carriage bolts M10x30 with washers and
locking nuts
5.
Bolts M10x70 with washers and locking nuts
6.
Brackets
7.
Upper Bracket
8.
Disconnect valve bracket
a) The support legs (2) are cut to proper lengths.
b) The mounting clamp (3) with two M10x30 bolts (4) for
the suspensions are inserted in the profile (1). Please
observe you insert these into the correct side of the
profile. Insert the Disconnect vallve bracket (8) between
the first and second suspension leg.
c) The mounting clamp for the hose/pipe bracket, see
"Hose connection mounting procedure" in this product
user manual, is inserted in the profile.
d) Drill two holes,in the support leg (2), one for the upper
and one for the lower bracket (6). Mount the Brackets
(6) to the support leg (2), the upper bracket can be
adjusted by up to 30 degrees if needed.
e) When the complete track (1) is adjusted correclty fix
the brackets by drilling a second and a third hole
through the brackets (5) into the support legs (2). Use
the pre-drilled holes in the brackets (6) and fix tightly
using the most centered holes.
WARNING
PRODUCT MAY CONTAIN SHARP EDGES
Use care when servicing unit. Failure to do so could
result in minor personal injury.
CAUTION
Before lifting the rail be sure that, the trolley is fixed
in its place, using both end stops. This to avoid injury
when trolley moves if the rail is uneven lifted.
