PLAYSTAR VARSITY BRONZE, Инструкция по безопасности и сборке

Страница: 7 / 72

A
B
C
A
B
C
7
1" x 4" or
2" x 4"
2" x 4"
2" x 4"
Your building kit includes a Drill Template
and an Assembly Tool Kit to help you
create some of the pilot holes needed to
build your playset.
Position the template and mark only the
holes that need to be drilled according to
the patterns shown below. Remove the
template before drilling.
WARNING: Do not drill
holes through the
template as you
may damage
the template.
TEMPLATE and DRILLING INSTRUCTIONS
Note: When the PlayStar logo is showing, the three tabs on the bottom will
position the template square with any two edges. When the arrow is
showing, the two tabs on the bottom will position the template square
with one edge only, which will allow you to slide the template
anywhere along the board.
PLEASE NOTE: Letters represent pattern not position
The rigid version of the template like the one shown here
can be found inside one of the hardware boxes.
Actual Size Template
T
E
M
P
L
A
T
E
F
O
R
D
R
IL
L
H
O
L
E
S
Set the drill bit depth in the
¹₈ " drill bit/countersink tool
to the thickness of the board.
(Fig. 1)
Drill locations as marked.
Warning: Do not countersink deeper than
the depth of the screw head.
In the assembly instructions, you will be asked to attach the
countersunk and predrilled boards with #8 x 2
¹₂ " deck screws.
To make this process easier, use
the predrilled boards as templates
for drilling pilot holes into the
second boards.
(Fig. 2)
Note: A second drill will make this process easier by eliminat-
ing multiple changes between drill bit and counersink tool.
(Fig. 2)
ADJUST
(Fig. 1)