Dual Lamp Control
64
scheduled time, WallNet will warn of the
impending switch for five minutes using Message
In Picture. After the five-minute warning period, it
typically takes about a minute to switch lamps.
✎
DO NOT
schedule a lamp switch and a color balance
at the same time. Color balancing can only be done
after
the lamps have been on for at least five min-
utes. If you are going to schedule color balancing
AND a lamp switch, schedule the lamp switch first.
Auto Color Balance After Lamp Failover
Select this option to enable an automatic color
balance after recovery from a failed lamp. If a
cube’s dual lamp system recovers from a lamp
failure by switching to the other lamp, this option
starts an Automatic Color Balance five minutes
after the new lamp begins operating.
CANCEL Pending Color Balance or Lamp
Switch
When there is a scheduled color balance or dual
lamp switch, there is a five-minute warning
period in which you can cancel the color balance
or lamp switch. During the warning period, a
message is displayed on the wall for about ten
seconds each minute.
Dual Lamp Status
Click
Get DLS Status Information
to view the
current dual lamp status.
Dual Lamp Control
Allows you to manually switch the lamps. You can
command each cube or all cubes to switch to
Lamp 1 or Lamp 2, or to switch to the opposite
lamp.
Содержание Wallnet
