Set Display IDs in WallNet
28
Set Display IDs in WallNet
Use the following instructions to set these same
numbers in a list in WallNet.
1
In the menu area, select RS232 Setup.
2
Select the baud rate at which the displays
are set. (See
✎
above.) Click
Change RS232
Settings
.
Note:
Your displays may support lower baud
rates that are not supported by WallNet. Some
advanced features, such as Auto Color Balance,
require higher baud rates to succeed.
3
If you want to view the on-screen serial
status menu, click
Show RS232/RS485
Status Menu
under the Serial Port Status
section. To hide the menu, click
Send Menu
Key
.
Note:
This is useful if you want to verify that all
display IDs are set to a unique value and that the
baud rate settings match.
4
Under the Enter Display IDs section, list the
display IDs in the box. Separate the IDs with
a space, comma, or put them on separate
lines. Click
Change RS232 Settings
.
5
If you want to confirm communication to
each individual display, do one of the
following under the Confirm RS232 Setup
section:
• Click
Report to browser only
.
• Click
Report to browser and on screen
.
• Click
View firmware version
information
.
When you are finished viewing the
information, click
Clear on-screen
messages
, if necessary.
The information in the report includes the
display model, firmware part number and
revision, and firmware compile date.
Содержание Wallnet
