Planar Wallnet, Настройка и эксплуатация

Страница: 29 / 88

23
Access Control
The Admin level can access everything. The
Operator can access View, but not Admin. View
can only access View.
When passwords are set, a dialog box pops up
the first time anyone tries to access a page that
requires a password. Enter
view , operator or
admin (always lower case) and the password to
gain access.
If you set the admin password and then forget it,
you can use the manual recovery procedures.
(See "Recovery Procedures" on page 75.)
However, you must be at the WallNet to do this.
You can’t do it remotely.
1 In the menu area, select Access Control.
2 Under the Web Access section, set the
passwords and confirm them. Then click
Set
for each level. (To remove a password,
delete the contents of password and
Confirm boxes and click
Set .)
3 Under Network Access, leave Enable
daytime service checked.
4 If you know you will use it, check Enable
ASCII command service (TCP/UDP port
57)
. Checking this box enables other
programs, such as MIP Maker or Remote
Control, to communicate with this WallNet.
These programs can use the network to find
and communicate with a WallNet and with
the displays to which it is connected. See
"ASCII Command Service" on page 69.
WallNet Admin
Network Setup
Date and Time
Access Control
WallNet Software
Admin
Save and Reboot
Save WallNet Config
Reboot WallNet
Admin &
Operator
Operation Security Level