Pioneer Elite SC-25 Скачать руководство пользователя страница 97

Страница: 97 / 154

Controlling the rest of your system (In case of SC-27)

Use

/

to select the proper code from the list,

then try using this remote with your component.

The code should start with the component type (for
example,

DVD 020

). If there is more than one, start with

the first one.

To try out the remote control, switch the component on or
off (into standby) by pressing



SOURCE

. If it doesn’t

seem to work, select the next code from the list (if there
is one).

• If you can’t find or properly enter a preset code, you

can still teach the remote individual commands from
another remote control (see

Controls the components

below).

If your component is controlled successfully, press

ENTER to confirm.

The remote LCD display shows

Programming signals from other
remote controls

If the preset code for your component is not available, or
the available preset codes do not operate correctly, you
can program signals from the remote control of another
component. This can also be used to program additional
operations (buttons not covered in the presets) after

assigning a preset code.

While pressing MULTI OPERATION, press HOME

MENU.

The remote LCD display shows

SETUP

Use

/

to select LEARNING, then press ENTER.

The LCD on the remote prompts you for the component
you want to control (for example

DVD

Press the input function button for the component

you want to control, then press ENTER.

PRES KEY

blinks in the LCD display.

Point the two remote controls towards each other,

then press the button that will be doing the learning on
this receiver’s remote control.
PRES KEY

lights to indicate the remote is ready to accept

a signal.

• The remote controls should be 3 cm (1 inch) apart.

Press the corresponding button on the other

remote control that is sending (teaching) the signal to
this receiver’s remote control.

For example, if you want to learn the playback control
signal, press and hold



briefly. The LCD display will

show

if the operation has been learned.

If for some reasons the operation hasn’t been learned the
LCD will display

ERROR

briefly, and then display

PRES

KEY

again. If this happens, keep pressing the (teaching)

button as you vary the distance between the two remotes,

until the LCD display shows

Certain buttons represent operations that cannot be
learned from other remote controls. The buttons
available are shown below:

Note

1 • When using a Pioneer HDD recorder, please select

PIONEER DVR

450

451

452

• When using a Pioneer flat panel TV released prior to summer 2005, please select preset code

644

2 The remote can store about 200 preset codes (this has been tested with codes of Pioneer format only).
3 • You can’t assign

TUNER

HOME MEDIA GALLERY

iPod USB

SIRIUS

• The

TV CONTROL

buttons (



TV VOL +/–

TV CH +/–

MUTE

and

INPUT

) can only be learned after the operation selection switch is set

4 Note that interference from TVs or other devices will sometimes result in the remote control learning the wrong signal.
5 • Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or

farther apart.
• If the remote LCD shows

FULL

, it means the memory is full. See

Erasing one of the remote control button settings

above to erase a

programmed button you’re not using to free up more memory (note that some signals may take more memory than others).

DVD

RECEIVER

SOURCE

MAIN

MULTI OPERATION

AUDIO