Pioneer Elite SC-25 Скачать руководство пользователя страница 104

Страница: 104 / 154

Controlling the rest of your system (In case of SC-25)

104

Repeat steps 1 through 3 for the other components

you want to control.

To try out the remote control, switch the component on or
off (into standby) by pressing



SOURCE

. If it doesn’t

seem to work, select the next code from the list (if there
is one).

Programming signals from other
remote controls

If the preset code for your component is not available, or
the available preset codes do not operate correctly, you
can program signals from the remote control of another
component. This can also be used to program additional
operations (buttons not covered in the presets) after

assigning a preset code.

Press and hold REMOTE SETUP, then release it after

the LED flashes twice.

Use the number buttons to enter 9, 7, 5.

The LED flashes twice.

Press the input function button for the component

you want to control.

Point the two remote controls towards each other,

then press the button that will be doing the learning on
this receiver’s remote control.

The LED flashes continuously for about 5 seconds.

• The remote controls should be 3 cm (1 inch) apart.

Press the corresponding button on the other

remote control that is sending (teaching) the signal to
this receiver’s remote control.

For example, if you want to learn the playback control
signal, press and hold



briefly. If the LED flashes twice

then turns off, this indicates that learning has been
successful. If the LED only flashes once, learning has

failed.

Certain buttons represent operations that cannot be
learned from other remote controls. The buttons
available are shown below:

To program additional signals for the current

component repeat steps 4 and 5.

To program signals for another component, exit and
repeat steps 1 through 5.

Erasing the remote control button
settings

This erases the buttons you have programmed and
restores the button to the factory default.

Press and hold REMOTE SETUP, then release it after

the LED flashes twice.

Use the number buttons to enter 9, 7, 6.

The LED flashes twice.

Press the input function button corresponding to

the command to be erased, then press the button to be
erased twice.

To erase all the settings stored at the input function
buttons, press the input function button twice here.

The LED flashes twice to confirm the button has been
erased.

Repeat step 3 to erase other buttons.

Note

1 The remote can store about 200 preset codes (this has been tested with codes of Pioneer format only).
2 • You can’t assign

TUNER

HOME MEDIA GALLERY

iPod USB

SIRIUS

• The

TV CONTROL

buttons (



TV VOL +/–

TV CH +/–

and

INPUT

) can only be learned after the

TV CTRL

is pressed.

3 The learning mode is cancelled if no remote control signal is received within 5 seconds.
4 • Note that interference from TVs or other devices will sometimes result in the remote control learning the wrong signal.

• Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or
farther apart.
• If the LED flashes once, it means the memory is full. See

Erasing one of the remote control button settings

above to erase a programmed

button you’re not using to free up more memory (note that some signals may take more memory than others).

DVD

DVR

HDMI

CD-R

TUNER

SIRIUS

HOME MEDIA

GALLERY

iPod USB