Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1
Function display
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
#
When the source icon is not displayed, you
can display it by touching the screen.
2 Press A.MENU button and touch INIT to
display the initial function names.
The function names are displayed and oper-
able ones are highlighted.
#
To go to the next group of function names,
touch
NEXT
.
#
To return to the previous group of function
names, touch
PREV
.
#
When the multi-channel processor (e.g., DEQ-
P7650/DEQ-P6600) is connected to this unit, you
can operate
D. ATT
and
RESET
instead of
REARSP
.
#
To return to the previous display, touch
BACK
.
#
To return to the display of each source, touch
ESC
.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
%
Touch FMSTEP on the initial menu to se-
lect the FM tuning step.
Touching
FMSTEP
will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
1,602 kHz allowable) to 10 kHz (530
1,640
kHz allowable).
%
Touch AMSTEP on the initial menu to
select the AM tuning step.
Touching
AMSTEP
will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
Initial Settings
En
84
Section
17