Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Touch NEXT on the DSP function menu.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-L
(front speaker left)
CENTER
(center
speaker)
FRONT-R
(front speaker right)
REAR-R
(rear speaker right)
REAR-L
(rear
speaker left)
SUB WOOFER
(subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
#
The settings do not appear for speakers
whose size is set
OFF
.
4 Touch
c
or
d
to adjust the speaker out-
put level.
Each time you touch
c
or
d
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
#
The test tone rotates to the next speaker after
about two seconds from the last operation.
5 Touch STOP to stop the test tone out-
put.
Notes
!
If needed, select speakers and adjust their
ab-
solute
output levels. (Refer to
Adjusting the
speaker output levels
on the previous page.)
!
To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at
SP LEVEL
. Both provide the same
results.
Using the time alignment
Only when the multi-channel processor (e.g.,
DEQ-P7650/DEQ-P6600) is connected to this
unit, you can operate this function.
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Touch NEXT on the DSP function menu.
2 Touch TIME ALIGN.
3 Touch any of the following touch panel
keys to select the time alignment.
!
INIT
Initial time alignment (factory set-
ting)
!
AUTOTA
Time alignment created by auto
TA and EQ. (Refer to
Auto TA and EQ (auto-
time alignment and auto-equalizing)
on
page 77.)
!
CUSTOM
Adjusted time alignment that
you can create for yourself
!
OFF
Turn the time alignment off
!
ADJUST
Adjust the time alignment as de-
sired
#
You cannot select
AUTOTA
if auto TA and EQ
has not been carried out.
#
You cannot select
ADJUST
when neither
FRONT-L
nor
FRONT-R
is selected in
POSITION (POSI)
.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
!
An adjusted time alignment is memorized
in
CUSTOM
.
1 Touch NEXT on the DSP function menu.
Digital Signal Processor
En
74
Section
15